Vinten protouch Pro-10 system Manuel de service télécharger pdf (Page 26)

Back

‘Pozi-Loc’ tripod leg clamp adjustment

Bedding-in occurs with ‘Pozi-Loc’ leg clamps, which may necessitate resetting the clamp. Check

the effectiveness of each leg clamp and adjust as follows:

Top clamp

Turn the clamp knob (21) to the vertical, ‘off’ position

Remove screw (21.1). Using a suitable peg spanner, back off the threaded insert (21.2) slot by

slot until the leg is free to move under its own weight.

While sliding the leg in and out, gradually tighten the threaded insert (21.2) until the clamp begins

to grip.

If not aligned, back off the threaded insert (21.2) until a slot aligns with the hole for screw (21.1).

Back off the threaded insert (21.2) a further three slots

Install screw (21.1) to secure the threaded insert (21.2).

Fig 9 Top clamp adjustment

(21.1)

(21.2)

(21)

1 2 ... 21 22 23 24 25 26 27 28 29

Pas de commentaire

Vinten protouch Pro-10 system Manuel de service Page 26